A feed supplement is a product that is added to an animal's diet to provide additional nutrients that may be lacking in the animal's regular feed. Feed supplements can come in many forms, including powders, pellets, liquids, and blocks, and can contain a variety of nutrients such as vitamins, minerals, amino acids, and probiotics. They are commonly used in livestock and poultry production to improve animal health, growth, and productivity. Some common feed supplements include calcium supplements for laying hens, probiotics for gut health in pigs, and electrolyte supplements for horses. Feed Supplement,Hot Supplement Soybean Lecithin Oil,Feed Supplement Puffed Corn Flour,Supplement Soybean Lecithin Oil Jiangsu Chenwei Biology and Technology Co. LTD , https://www.cwsoybean.com
Install dehydrated vegetable dryer to operate correctly
With the development of technology, this dryer has the ability to meet large production, diversification, centralized control and continuous production. It has the advantages of high efficiency, energy saving, etc., and in order to work better, it needs to be very careful during installation. , step by step as required.
Dehydrated vegetable dryer installation:
1. Draw the basic line: Make the cross line, the elevation line and the center mark on the basic target board to be easy to use, accurate and consider not to be covered after the base is installed.
2. Install the base and the tug: shovel the position of the horn, draw the base, the center line of the tug, according to the requirements of the drawings, find the installation position of the base and the tug, level and correct, first grout the foundation hole, and the concrete reaches a certain strength. When the anchor bolts are tightened, the cylinders are installed after the inspection is passed.
3. Install the cylinder and the rolling ring: firstly install the rolling ring on the cylinder. The concave joints required for fixing should be arranged in a reversed and reversed manner, and the thickness of the horn should be adjusted to keep the contact between the rolling ring and the concave joint. For the corresponding clearance, do not agree, and spot weld the concave joint bolt head and the cylinder body.
4. Install the big gear: Check the interface of the mating surface before installation, there must be no collision marks, clean the contact surface between the large gear and the cylinder, then carefully align the two halves of the gear and tighten the interface bolts, then install the large gear in the cylinder Physically. Rotate the barrel and check the radial runout and lateral swing of the large gear until the calibration is passed.
In general, the residence time of the mesh belt type dehydrated vegetable dryer in the middle section and the final drying section is three to four times that of the initial drying section, and the thickness of the paving is two to three times that of the initial drying section, effectively improving the drying. The output provides conditions for users to produce in large quantities in batches.