Corn, also known as wheat, maize, grain, it is one of the world's three major food crops, planting area and yield after rice and wheat, ranked third.More because of good mouth, high heat, large yield, and is widely used in a variety of livestock feed, thus known as the "King of Feed", in addition, corn is also the three food crops most suitable for industrial raw material crops, its processing of industrial products as high as more than 3000 kinds.
If you have any questions, please leave a comment on this website or contact us using email.
Steam Sweet Corn Cut,Sweet Maize Cut,Fresh Sweet Corn Cut,Baked Sweet Corn Cut Jilin Province Argricultural Sister-in-law Food Co., Ltd. , https://www.nongsaocorn.com
Second, the rear wheel axle assembly walking tractor rear wheel rotating part of many parts, poor working conditions, must be removed after the end of the quarter operations to clean, add grease lubrication; check the seal of the seal, if there is damage should be replaced . Do not think that the tail wheel can still rotate without having to maintain, once the bearing is stuck, the trouble of the journal can be great.
3. Sleeve Axle Bushing Sleeve Axle Bushing is working in harsh environments with many dust and moisture, and is easily worn or damaged. Do not think that the boring axis can be rotated without maintenance, otherwise it will cause the journal to be worn, damaged or even scrapped. During maintenance, remove impurities such as sand grains embedded in the sleeve and add calcium-based grease to lubricate. If the sleeve wears badly, replace the new sleeve.
4. Rotary cultivator coulter shaft bearing walking tractor The 308 bearings on the right side of the ploughshare plough shaft together with the coulter gearbox are lubricated with gear oil. Some operators ignore the left 207 bearing to use calcium. Based on grease lubrication, this will cause the bearing to dry out of oil, heat stuck in the operation, and even make the bearings run in a circle, the journal severely damaged and scrapped. Therefore, the oil seal and bearing on the left side of the coulter shaft should be removed during the maintenance. After cleaning with diesel oil, add calcium-based grease.
Fifth, the ditching machine depth limit wheel bearing walking tractor with the disc ditch depth limiter wheel fittings are equipped with two 60204 bearings at both ends, the bearing is equipped with a cover waterproof, do not think that the depth of the wheel can turn Do not take care, otherwise it will cause the axle to become stuck. Maintenance can be done after the end of each quarter, remove the lower limit deep wheel, remove the 60204 bearing clean diesel oil, and then add calcium-based grease lubrication.
Sixth, seed drill clutch type seed drill seeding clutch, due to poor sealing, easy to enter the dust to make the grease dry, resulting in clutch work failure. Therefore, before each season sowing operation, the clutch of the seed type should be dismantled, the internally deteriorating grease should be removed, and new calcium-based grease should be added.
7. The threshing machine roller bearing roller bearing works under the conditions of many dust and high humidity. Do not think that the roller can rotate and ignore the maintenance, otherwise it will cause early wear and even scrapping of the roller journal. Before each quarter of operation and operation, attention should be paid to inspection, grease lubrication should be added in time, and bearings that are seriously worn or damaged should be promptly replaced.
Agricultural machinery can not ignore several "oil" parts
First, the clutch release bearing in the agricultural machinery to carry out ditching, rotary tillage, sowing and other operations, the clutch is used very frequently, but also easy to damage, can not be ignored. The clutch release bearing should be maintained before each quarterly operation by removing the separating claw and separating the bearing, cleaning and drying with diesel oil or kerosene, and heating in a container filled with calcium-based grease to allow the thermal grease to infiltrate into the bearing. Inside, then remove and install it.